Warranty
on all our products
FREE SHIPPING
within the 48 States

52 Degree X 38 Degree Crown Molding Miter Router Bit - 1/2" Shank - Yonico 16143

$26.95
Short description:

Cut 52°/38° back angles on crown moldings and cornices with the Yonico 16143 Crown Molding Miter Router Bit. As an alternative to 45° installation, 52°/38° angles enables moldings and cornices to be installed at the tilt with the most eye appeal. While high ceiling crown moldings will show best when angled downward, a crown molding installed on a low ceiling or a cornice installation will look best when angled upwards. For higher ceilings, route the ceiling edge with the stock face up, then flip over and route the wall edge face down. For lower ceilings, route the wall edge with the stock face up, then flip over and route the ceiling edge face down. Note: Be sure to cut angles before routing the actual molding profile to enable precise angle cuts. Two flute carbide cutters with ball bearing guide. Largest diameter is 2-3/8" and cutter height is 1-9/16". Shank is 1/2".

16143
In stock
+

Cut back angles on crown moldings and cornices with Yonico's Crown Molding Miter Router Bit. As an alternative to 45° installation, 52°/38° angles enables moldings and cornices to be installed at the tilt with the most eye appeal. While high ceiling crown moldings will show best when angled downward, a crown molding installed on a low ceiling or a cornice installation will look best when angled upwards.

Bit Specs

Material:
Carbide Tipped
Number of Bits:
1
Shank Size :
1/2"
Cutting Length:
1-1/2"
Cutting Depth:
1"
Overall Length:
3-3/8"
Largest Diameter:
2-3/8"
Degrees:
52°/38°
Number of Flutes:
2

General Info

Release Date:
12/10/2012
Condition:
New
Item #:
16143
UPC:
765573827163
Brand:
Yonico
Product Type:
Crown Molding Miter Router Bit
Manufacturer:
Yonico
MPN:
16143
Weight:
0.54 lbs.